Unsupported Browser
The web browser that you are currently using is no longer supported, and as such features of this website may not work as expected. We advise you to update to a currently supported browser (such as Chrome, Edge, or Firefox) to improve your security, speed, and overall experience.
Supplied with Audio-Technica's versatile UniMount clip and new violin mount, the low-profile ATM350 is an exceptional cardioid condenser microphone designed to clip to brass, reeds, piano, snare, toms, and violin.
Product Ref: 19082
The microphone offers a crisp, clear, well-balanced response, even at high SPLs. It features an integral 80 Hz hi-pass filter and is also equipped with a new in-line power module. Its cardioid polar pattern reduces pickup of sounds from the side and rear for effective protection against feedback.
The ATM350 is intended for use in professional applications where remote power is available. It requires 11V to 52V DC phantom power, which may be provided by a mixer or console, or by a separate, in-line source such as the Audio-Technica AT8801 singlechannel or CP8506 four-channel phantom power supplies.
An integral 80 Hz high-pass filter provides easy switching from a flat frequency response to a low-end roll-off. The roll-off position reduces the pickup of low-frequency ambient noise (such as traffic, air-handling systems, etc.), room reverberation and mechanically coupled vibrations.
Output from the power module's XLRM-type connector is low impedance (Lo-Z) balanced. The signal appears across Pins 2 and 3; Pin 1 is ground (shield). Output phase is "Pin 2 hot" - positive acoustic pressure produces positive voltage at Pin 2. To avoid phase cancellation and poor sound, all mic cables must be wired consistently: Pin 1-to-Pin 1, etc.
To use the violin mount, place the microphone in the violin mount's elastic mic holder. Open the hook & loop fastener; pass the hook side of the open fastener beneath the strings between the bridge and the tailpiece. Close the fastener flap around the strings. The microphone should be on top, with the element facing the bridge (away from the tailpiece).